what is the torque of the screws on an Sedna O11D EVO-N

Question

My distro plate is getting quite dirty, after opening it up and cleaning it how much torque should i tighten the screws. Thank you

Answer 1

Dear Customer,

The torque of the screws on a Sedna O11D EVO-N is about 4 kgf-cm.
After re-installing the distro plate, please do a leaking test and make sure there is no leaking.
If you have any questions, please don't hesitate to contact us.

Answer 2

The torque of the screws on a Sedna O11D EVO-N case is critical for ensuring a secure and stable build, especially when installing components like cooling systems or GPUs. Over-tightening can damage the case or components, while under-tightening might lead to instability. Much like strategizing in Whiteout Survival codes, where each decision impacts your survival journey, properly setting the screw torque ensures the success and durability of your PC build. Paying attention to these details helps achieve a balanced and optimal setup for performance and longevity.

Answer 3

When reassembling your Bitspower Sedna O11D EVO-N distribution plate after cleaning, it's important to avoid over-tightening the screws to prevent damaging the acrylic. While the exact torque specification isn't explicitly provided, similar distribution plates typically recommend a torque setting of around 0.6 Newton-meters (Nm).

If you don’t have a torque screwdriver, tighten the screws until they are snug but not overly tight. Acrylic can crack if too much force is applied. After reassembly, it's recommended to perform a 24-hour leak test by running the pump independently to ensure all seals are secure and there are no leaks.

4o

O