asked in Technical problem by
My distro plate is getting quite dirty, after opening it up and cleaning it how much torque should i tighten the screws. Thank you

2 Answers

answered by (116k points)
Dear Customer,

The torque of the screws on a Sedna O11D EVO-N is about 4 kgf-cm.
After re-installing the distro plate, please do a leaking test and make sure there is no leaking.
If you have any questions, please don't hesitate to contact us.
answered by (260 points)

When reassembling your Bitspower Sedna O11D EVO-N distribution plate after cleaning, it's important to avoid over-tightening the screws to prevent damaging the acrylic. While the exact torque specification isn't explicitly provided, similar distribution plates typically recommend a torque setting of around 0.6 Newton-meters (Nm).

If you don’t have a torque screwdriver, tighten the screws until they are snug but not overly tight. Acrylic can crack if too much force is applied. After reassembly, it's recommended to perform a 24-hour leak test by running the pump independently to ensure all seals are secure and there are no leaks.

 

 

 

 

 

...